Fits Dodge and Jeep 2000- up with the RE series transmission 42RE, 44RE, 46RE, 47RE and 48RE.
Governor pressure sensor has rectangle 4 pin connector. Governor solenoid is 2 pin.
The transmission control module (computer) changes the duty cycle (voltage) to the governor solenoid to control governor pressure. Governor pressure is what is used to stroke the shift valves in the valve body to make the transmission shift. The governor sensor measures the governor pressure in the circuit to tell the computer to add or take away pressure. If either the solenoid or sensor fail you may have a no shift, wrong gear starts or shift timing issues.
These are very common parts to fail. They should be replaced during transmission rebuilds.
This Borg Warner solenoid is an upgraded solenoid over the OE solenoid.
The solenoid base gasket is included in this kit.
Have questions please ask.
Dodge transmission questions? Were here to help.
Interchange Part Numbers:
OE # 56028196AD / 4617210
Transtar # 12415C / 12432H
WIT # 12415C / 12432A
Natpro # 12878C / 12877HD
Brand: upgraded Borg Warner solenoid – OE sensor
1 Review Hide Reviews Show Reviews
Kit comes with the upgrade Borg Warner solenoid, OEM sensor and governor block gasket. Be sure to slide the governor heat shield/retainer plate into the upper grove machined into the solenoid. The factory solenoid only has one groove. The wiring harness must be rotated 180 when plugging the solenoid in. No special tools outside of Torx 25 bit. Everything worked nicely. No more P1762 code. Shifts are noticeably crisper and less sloppy feel from a dead stop. Shipping was super fast. Thanks!